WAM® 90 WFS – 90% Alumina Based Wire Fiber Slurry

WAM® 90 WFS is a multiple purpose high temperature/low reactivity slurry mix used to cast high wire fiber containing precast shapes. Tabular alumina is the base aggregate for this material. This allows the slurry itself to be suitable for use up to 3100oF.

 

WAM® 90 WFS is designed to be self flowing at minimal water content. Under vibration, flow increases and de-airing is easily accomplished. WAM® 90 WFS is used to fabricate shapes for a variety of applications within the steel and aluminum industries.

Typical Technical Data
WAM® 90 WFS                                                                                      
PDF Download

Classification:Slurry Mix
Placement Method:Self Flow / Vibration Casting
Available Application Packages:AL - Aluminum Penetration Resistant
Typical Water Requirement (%wt):10-12
Material Required for Estimating (lb/ft3): dependent on needle content
Maximum Recommended Service Temperature (°F):3100
Screen Sizing (% passing 48 Mesh):+95

CHEMICAL ANALYSIS
Calculated wt.% Based on Common Oxides

Aluminum Oxide (Al2O3):89.1 %
Silicon Dioxide (SiO2):7.9 %
Titanium Dioxide (TiO2):<0.1 %
Iron(III) Oxide (Fe2O3):0.1 %
Calcium Oxide (CaO):2.5 %
Magnesium Oxide (MgO):0.1%
Combined Alkali Oxide (Na2O + K2O):0.3 %

Additional technical data may be available. Please contact your sales representative for more information.
Data on this table represent typical properties and cannot be used for specification purposes.